房产印刷气体反应了人们维持生计和访学的问题。对此事，我国授于相干的权利法案条则，菅理房产印刷气体乱环保问题物的之景。传统，VOCs印刷气体包括几类，可不溶水的、劝慰性强、臭气强等范列，此中首遵循加硫物、苯类、脂类、烃类等有机物印刷气体;倘若此类天然气隐性环保问题物，不只会破碎机图片包气动态平衡，还会持续安全隐患两侧生物工程安康。是以如果根据印刷气体处里的共同点停止工作菅理是首当其冲的，也是急待处里的，后面吉丰科学技术就如果根据VOCs印刷气体对问题的环保问题及处里体例先容！Industrial waste gas affects the environment in which we live and study. In response, the country has issued relevant legal provisions to address the phenomenon of indiscriminate discharge of industrial waste gas. Generally, VOCs waste gas can be classified into several types, such as water-soluble, highly irritating, and odorous. Among them, the main organic waste gases are sulfides, benzenes, lipids, hydrocarbons, etc; If these toxic gases are directly emitted, it will not only disrupt the atmospheric balance, but also endanger the health of surrounding organisms. Therefore, it is urgent and urgent to carry out treatment based on the characteristics of exhaust gas treatment. Below, Jifeng Technology will introduce the pollution and treatment methods of VOCs exhaust gas on the environment!VOCs有机废气物对情況影响：VOCs exhaust gas causes environmental pollution:51漫画尾气中VOCS的情况前提有二甲苯、四甲苯、乙酸丁酯等，类物质反衬繁杂，且凝固点大都反衬高（117.6-196.8℃）。VOCs51漫画尾气要具备有机51漫画废气浓度高、严重污染严格，在51漫画尾气服务管理上临技术施工工艺的提起也周期常严酷的，是以选购专业的的技术规划周期多有需耍的。The main components of VOCs in exhaust gas are xylene, tetramethylbenzene, butyl acetate, etc. The components are relatively complex, and the boiling points are mostly high (117.6-196.8 ℃). VOCs waste gas has high concentration and serious pollution, and the technical requirements for waste gas treatment are also very strict. Therefore, it is necessary to choose a professional technical solution.

VOCs印刷废气外理还可以用的体例：Methods that can be used for VOCs waste gas treatment:1、待防范高分子气体进到蓄热室1的卫浴瓷质物质层（该卫浴瓷质物质“低温干燥”了去轮回转世的热能量），卫浴瓷质开释热能量，热度的降底，而高分子气体接受到热能量，热度降底，气体独立蓄热室后以较高的热度进到脱色室，这个时候气体热度的事业线考量于卫浴瓷质体体积大概、气体流体密度和卫浴瓷质体的或多或少规划。1. The organic waste gas to be treated enters the ceramic medium layer of the heat storage chamber 1 (which "stores" the heat from the previous cycle). The ceramic releases heat and the temperature decreases, while the organic waste gas absorbs heat and the temperature increases. After leaving the heat storage chamber, the waste gas enters the oxidation chamber at a higher temperature. At this time, the temperature of the waste gas depends on the volume of the ceramic body, the flow rate of the waste gas, and the geometric structure of the ceramic body.2、在脱色室中，有机51漫画废水排放再由灭掉器加温煮沸至控制在的脱色温湿度760℃，使此中的VOC化学成分的材料细胞分化成二脱色碳和水。可能51漫画废水排放已在蓄热地下室变热，生物燃料耗量大幅大幅度降低。脱色室有多个影响：更是保险51漫画废水排放能去往控制在的脱色温湿度，二保险有比较充足的停留时间使51漫画废水排放中VOC不断丰富脱色。 51漫画废水排放在脱色室中灭掉，是空气环境空气污染的超低温有害气体后分别脱色室，进人蓄热室2（在后期的宿命中已被冷却水），放热反应加温后排座挤，而蓄热室2接受成批卡路里后煮沸（适用下一位宿命加温51漫画废水排放）。空气环境空气污染后的51漫画废水排放经烟筒排放大气气溶胶，此外引小股空气环境空气污染气打扫卫生蓄热室3。排气管温湿度比进平均温度湿性强40℃摆弄。2. In the oxidation chamber, the organic waste gas is heated by the burner to the set oxidation temperature of 760 ℃, causing the VOC components to decompose into carbon dioxide and water. Due to the preheating of exhaust gas in the heat storage chamber, fuel consumption is greatly reduced. The oxidation chamber has two functions: one is to ensure that the exhaust gas can reach the set oxidation temperature, and the other is to ensure sufficient residence time for the VOCs in the exhaust gas to be fully oxidized. The exhaust gas is incinerated in the oxidation chamber and becomes purified high-temperature gas before leaving the oxidation chamber and entering the heat storage chamber 2 (which has been cooled in the previous cycle). After releasing heat and cooling down, it is discharged, while the heat storage chamber 2 absorbs a large amount of heat and heats up (used to heat the exhaust gas in the next cycle). The purified exhaust gas is discharged into the atmosphere through the chimney, while a small stream of purified gas is introduced to clean the heat storage chamber 3. The exhaust temperature is about 40 ℃ higher than the intake temperature.3、重复体现后，进气与撒气调节阀停止工作第一次锁定，步入下的重复，51漫画废气由蓄热室2步入，蓄热室3不待见。互相引回两局部感染气打扫房间蓄热室1。重复往复式，定期每日任务。3. After the cycle is completed, the intake and exhaust valves are switched once to enter the next cycle. The exhaust gas enters from the heat storage chamber 2 and is discharged from the heat storage chamber 3. Simultaneously introducing a portion of purified gas to clean the heat storage chamber 1. Repeat the cycle, work continuously.VOCs有机废液途经进度有机废液搜集资料配备，将VOCs有机废液经髙压生产的风机超出RTO制度内加热，热度晋升制度后停此超高温脱色两极分化，包括无毒无害、有意义的超高温尾气。本装置将灭掉后的超高温尾气用蜂窝状瓷质蓄热体把电磁能收受移交并茶叶保存，可收受移交热能超越95%，在有机废液发动机预热，顺利到达健康节电的最终目标。VOCs waste gas is collected by a waste gas collection device and sent to the RTO system through a high-pressure fan for heating. After the temperature is raised, it undergoes high-temperature oxidation and decomposition, forming non-toxic and odorless high-temperature flue gas. This device recovers and stores the heat energy from the high-temperature flue gas after combustion using a honeycomb ceramic thermal storage body, with a heat recovery rate of over 95%, which is used for preheating exhaust gas and achieving the goal of environmental protection and energy conservation.

本文由VOCs废气处置友谊贡献.更多有关的常识请点击://www.hbsgqt.com咱们将会对您提出的疑难停止具体的解答，接待您登录网站留言.

This article is dedicated to friendship For more information, please click: We will provide detailed answers to your questions. You are welcome to log in to our website and leave a message

上一篇：若何挑选合适的涂装流水线设备？
下一篇：产业涂装流水线有哪些工艺流程？